La Crosse Technology WS-9025U - Manual (Page 20)

TOGGLING AND RESETTING THE OUTDOOR RECORDINGS:
1. To toggle between the outdoor current, MIN/MAX temperature and
humidity data and the times (for temperature data only) they were
recorded press the MIN/OUT key:
Once to show the MAX outdoor temperature and humidity data with the
recorded time and date.
Twice to show the MIN outdoor temperature and humidity data with the
recorded time and date.
Three times to return to the current displayed values.
2. To toggle between sensors, press the CH/+ key:
Once to show sensor 2
Twice to show sensor 3
Three times to return to sensor 1
Note: The sensor number will only be displayed if there is more than one
sensor being used.
3. To reset the MIN/MAX outdoor temperature, and the time at which they
were recorded, press and hold the MIN/OUT key for about 4 seconds.
This will reset all MIN/MAX data recorded to the displayed values for
that particular sensor.
TO EXIT THE MANUAL SETTING MODE
To exit the manual setting mode anytime during the manual setting modes,
press the SNOOZE key anytime or wait for automatic timeout. The mode will
return to normal time display.
BACK-LIGHT
The back-light is automatically switched ON when any keys are pressed. The
back-light will be switched on for approximately 10 seconds before
automatically switching OFF. However, if the SNOOZE key is pressed and
held down, then back-light will remain ON constantly until the key is released.
ABOUT THE OUTDOOR THERMO-HYGRO SENSOR
The range of the Thermo-hygro Sensor may be affected by the temperature.
At cold temperatures the transmitting distance may be decreased. Please bear
this in mind when positioning the sensor. Also the batteries may be reduced in
power.
CHECKING FOR 433MHz RECEPTION
If the outdoor temperature and humidity data is not being received within
three minutes after setting up (the display shows “- -. - °F” and “- -%” on the
outdoor section of the Weather Projection Station after 3 attempts during
normal operation), please check the following points: