Land Pride RB45108 User Manual
Page 11
9
Section 1: Assembly and Setup
5/21/07
RB4596, RB45108 & RB5596 Rear Blade 301-133M
Land Pride
Manual Tilt and Offset Assembly
Figure 1-7
15003
Blade Angling
Blade Tilting
Manual Blade Offset
Refer to Figure 1-7:
1.
Attach blade offset links to the left or right side
of the blade as shown with two clevis pins and secure
with hair pin cotters.
2.
Adjust offset angle by removing the hitch pin and
moving outer link to a different hole. Replace hitch
pin and secure with hair pin cotter.
Manual Blade Tilting
Refer to Figure 1-7:
1.
Attach ratchet jack to the back side of the blade as
shown with two 1" clevis pins and secure with hair pin
cotters.
2.
Adjust blade tilt by setting the lock on the ratchet
lever and pumping the lever back and forth to raise
one end of the blade higher than the other end.
Reposition ratchet lock and pump lever back and
forth to tilt blade in the opposite direction.
Skid Shoe Option
Refer to Figure 1-8:
The skid shoes are attached to both ends of the blade to
help prevent damage to the surface of the ground by the
blade.
Kit Bundle
301-110A
SKID SHOE ASSEMBLY
1.
Attach skid shoe bracket (#1) with 1/2"-13 x 4 1/2"
GR5 hex head cap screw (#5), flat washers (#6),
spring lock washer (#7) and hex nut (#8). Tighten
hardware to the correct torque.
2.
Insert skid shoe (#2) into skid shoe bracket (#1).
Secure with clevis pin (#3) and hair pin cotter (#4).
3.
Repeat steps 1 and 2 for the other side.
Skid Shoe Assembly
Figure 1-8
10350