Lenoxx Electronics CD-107 - Manual (Page 5)

CHOOSING THE POWER SOURCES
You can use the AC power or batteries as a power source.
TIP
•
If the plug of the AC
power cord does not
match your outlet, do not
force it.
Reverse it and try again.
The plugs are polarized
and only fits one way into
the wall outlet and back
of the set.
• Replace the batteries
when the POWER lamp
dims or when the player
stops operating. Replace
all the batteries with new
ones. Before you replace
the batteries, be sure to
take out the CD from the
player and remember to
check the Battery Safety
Instructions on Page 3.
1. Connecting the AC power
cord
Insert one end of the supplied AC power cord
(located in the battery compartment) into the socket
located at the rear of the player, and the other end
to the wall outlet.
2. Using the player on batteries
Insert 6 size “C” batteries (not supplied) into the
battery compartment.
To use the player on batteries, disconnect and
remove the AC power cord from the player.
4
AC SOCKET
Battery compartment
To a wall outlet
NOTE: One blade of plug
and outlet is wider.
!
#
"
$
upper
upper
lower
Insert new batteries
according to sequence
as shown on FIG. 1.
+
+ +
+
FIG. 1
FIG. 2
To remove the batteries,
(open the door) stick
your finger into the hole
on the bottom of the set
and push the batteries
out as shown on FIG. 2.
IB-CD107(AD)-FD-E-V1