Lennox Hearth 290M - Manual (Page 2)

2
Printed in U.S.A. © 2008 Lennox hearth Products
P/N 775,290M REV. A 10/2008
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Step 5. Using a 3/8” open end wrench, install the front door trim with
the four supplied nuts and washers. DO NOt OVERtIGhtEN thE
NUtS OR SCREwS. See Figure 5.
Step 3. Using a 5/32” allen wrench, attach the louvers above the door
with four supplied screws (two on left side and two on right side
of stove). See Figure 1 on Page 1.
Step 4. Slide the side window trim down into the brackets in the side wall
of the stove. It may be helpful to slightly pry open the brackets
on the stove to slide the side trim in. Be careful to not scratch the
glass or the trim. See Figure 4.
Step 6. Reattach the top of the stove with the four screws.
Step 7. To install the spring handle, first close the door and screw the
handle into the receiving nut. Then spray a household glass cleaner
or water on the shaft of the handle to act as a lubricant. Next,
twist the spring handle counterclockwise onto the shaft. Use a
household glass cleaner or alcohol and a soft cloth to remove
any fingerprints from all plated surfaces prior to firing the stove.
Read Caution on Page 1.
Figure 4
Figure 5
Lennox Hearth Products reserves the right to make changes at any time, without notice, in
design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
1110 west taft Avenue • Orange, CA 92865
Figure 6
COMPLEtED
INStALLAtION
Front Door trim
Step 2. Using a 5/32” allen wrench, attach the ash lip to the lower control
door using two supplied screws. See Figure 3.
Figure 3
5/32” Allen wrench