Lightolier Architectural Decorative CCLRD01 - Manual

Lightolier is a Philips group brand
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • A0908
Architectural Decorative
IS:CCLRD01
Page 1 of 3 Instruction Sheet for Assembly and Installation
Read and understand these instructions before installing luminaire
This luminaire control is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes
and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
Introduction
Color rotary dial control is a digital lighting controller that features eight
pre-programmed effects, plus OFF. Effect selection and modification is
easy with the rotary knob. Push to cycle through the effects and turn to
vary the color or speed. Color rotary dial control is packaged in an easy to
use, wall-mount assembly.
Included in this box:
Color Rotary Dial Control
Knob
Note: Face Plate (supplied by others)
Fig. 1
• Color rotary dial control assembly
• Knob
• (2) 6-32 Phillips flat head screws
Additional items needed:
• Single or multi gang wall box
• CAT 5 data cable, unshielded twisted pair, flying lead/RJ-45
• 18 AWG power cable with flying leads or 18 AWG power cable with
BNC connector and coupling. Refer to the wiring diagrams to deter-
mine your installation requirement.
• Face Plate
Identification and Warnings of Safety Hazards
In accordance with ANSI Z535.4 the following system of identifying the
severity of the hazards associated with the products is used:
“
Danger” Imminently hazardous situation which, if not avoided, will
result in death or serious injury.
“ Warning” Potentially hazardous situation that, if not avoided, could
result in death or serious injury.
“ Caution” Potentially hazardous situation that, if not avoided, may
result in minor or moderate injury or property damage.
Warning: Ensure that main power supply is off before installing, wiring,
or servicing the color rotary dial control. Failure to adhere to these
instructions can result in death or serious injury.
Warning: The color rotary dial control must be installed by a qualified
professional in accordance with NEC and relevant local codes. Failure to
comply can result in death, serious injury, or property damage.
Warning: Do not attempt to install or use the color rotary dial control
until you read and understand the installation instructions and safety
labels. Failure to adhere to these instructions could result in serious injury
or property damage.
Caution: Do not modify or alter the color rotary dial control. Doing so will
void the warranty.
Caution: Color rotary dial control has no user serviceable parts. Do not
open. Doing so will void the warranty.
Owner/User Responsibilities
It is the responsibility of the contractor, installer, purchaser, owner, and
user to install, maintain, and operate the color rotary dial control in such
a manner as to comply with all state and local laws, ordinances, regula-
tions, and the American National Standard Institute Safety Code.