Lucent Technologies Voice Terminal 8403 - Manual (Page 22)

19
Select Ring (and Ringer Volume)
To select a personalized ring 1 While on-hook, press , and then press
•
Red light next to blinks during the Select Ring
process
•
Voice terminal plays the current ringing pattern
2 Press again to hear the next ringing pattern
Note: There are eight different patterns; the cycle repeats
after the last pattern.
3 When you hear the desired ringing pattern,
press
•
Your new ringing pattern is set; the selection process ends
•
Red light next to goes off
Note: If you receive a call, go off-hook, or lose power
during selection, the process is interrupted and you must start
again.
✔
Feature Hold
Feature
Hold
Feature
Feature
To adjust ringer volume
if necessary 1 While the handset is on-hook and the speaker is off, or if the
voice terminal is ringing when the handset is off-hook:
Raise the volume by pressing the right half of the
Volume control button labeled
;
or lower the volume by pressing the left half of the
Volume control button labeled
(There are eight possible volume settings.)