820ir, Five-year limited warranty, Contact us – LightSpeed Technologies 820iR User Manual

Page 2

Advertising
background image

NOTE!

Most problems are directly related to low

battery power. Please run through the “Battery
Check” items first. For remaining troubleshoot-
ing, use known good, fully-charged batteries.

Battery Check

• Confirm

batteries are charged

each night.

• Confirm

proper batteries are

used. The REDMIkE requires the

Lightspeed BA-NH2A27 sensing

battery for proper charging.

• Make

sure the REDMIkE is turned off

while charging so that it will attain

a full charge. Full charge will last

seven hours.

• Inspect

the battery contacts. Clean

and adjust if necessary.

Hearing Static

• Ensure

sensor is in optimum

location (refer to sensor placement

in manual). A single sensor will

cover a 1600 sq. ft. enclosed

classroom.

• Ensure

that no other REDMIkE/

LT71/HM70 is operating on the same

channel.

• If

an external microphone is in

use, try another REDMIkE that is

known to be working (if available) to

isolate the problem. If static persists

with “known good” microphone,

the REDMIkE input jack will need

service.

Low Volume or Feedback

Ensure

microphone is positioned

appropriately, just below the

collar bone.

• Check

volume level on the amplifier.

If the volume is too high, feedback

will occur. Adjust accordingly.

No Sound From Speaker

• Turn

the 820iR on. Confirm that the

POwER light located on the power

switch is on.

• Confirm

signal is being received at

the 820iR. The IR signal light will be

lit (RED) indicating a signal is being

received.

• Confirm

that REDMIkE is turned on.

There will be a BLUE LED on

the microphone to indicate it is

powered on.

TROUBLESHOOTING GUIDE

1

TIPS ON CLASSROOM AUDIO

Avoid

wearing jewelry that may rub or bump against

the microphone.

Turn

the REDMIkE off during private conversations with a student,

parent, or other classroom visitor. You can also cover the LED
lens on top of the REDMIkE to block the signal.

Recharge

batteries each night. when recharged nightly, operating

time (actual usage) for the transmitters will last through a typical
school day.

Five-year Limited Warranty

Lightspeed Classroom Audio Systems are guaranteed against malfunction due to defects
in materials and workmanship for a period of FIVE (5) YEARS, beginning at the date of
the purchase invoice. If such malfunction occurs, the product will be repaired or replaced
(at Lightspeed’s option) without charge during the warranty period.

1. warranty on infrared microphones is FIVE (5) YEARS.

2. warranty on Lightspeed rechargeable batteries, all external cables and wires provided

by Lightspeed is one (1) year.

3. Prepaid shipping labels are provided by Lightspeed factory or an authorized warranty

service center for warranty repairs.

4. Warranty does not extend to finish, appearance items, or malfunctions due to abuse

or operation other than specified conditions, nor does it extend to incidental or
consequential damages. Repair by other than Lightspeed or its authorized service
agencies will void this guarantee. Information on authorized service agencies is
available from Lightspeed Technologies, Inc.

2

3

4

Speak

in a natural voice. A normal conversational speech level

will provide an adequate signal. It is not necessary to increase
the intensity of your voice—the audio system provides
adequate amplification (approximately 5 – 10 dB) above
ambient room noises.

Our Service Department (800.732.8999, 5 a.m. – 5 p.m., PST)

will handle all your repair/replacement needs.

LIGHTSPEED TECHNOLOGIES, INC. | www.LIGHTSPEED-TEk.COM | 800.732.8999

Contact us:

LIGHTSPEED TECHNOLOGIES
11509 Sw HERMAN ROAD | TUALATIN, OREGON 97062
TOLL FREE: 800.732.8999
PHONE: 503.684.5538 | FAX: 503.684.3197
www.LIGHTSPEED-TEk.COM

MN0008US01-0

Classroom Audio System

820iR

Advertising