Lyngdorf Audio W-210 - Manual (Page 3)

3
Connecting
When connecting the W210s, always connect ”+” and ”-” from the amplifi er to the corresponding ”+”
and ”-” terminals on the W210 input.
Connect your speakers the same way to avoid phase errors.
Set-up of cut-off frequency
To match most speakers bass response, we recommend a cut-off frequency at 400Hz. But depending
on you speakers and room, the cut-off frequency can easily vary from 200-800Hz. Try experimenting to
get the best sound.
Level
Adjust the level of the W210s to match the sound level of your main speakers.
If applying RoomPerfect you can set the volume of the W210s a few dB to loud before making the
RoomPerfect calibration. RoomPerfect will then lower the bass to an appropriate level.
Cleaning
Please use a dust-free cloth to clean the speakers. It is also possible to use a slightly damp cloth for more
stubborn marks.
Under no circumstances should you use any kind of cleaning agent on, or in close proximity to, these
speakers.
Specifi cations
Product W210
Woofer/midrange driver 2 x 10”
Frequency response 16 - 3500 Hz
Sensitivity (2.83V/1m) 96dB
Nominal Impedance 8 Ohm