Little Wonder OPTIMAX 2/1/1990 - Manual (Page 10)

10
LITTLE
WONDER
BLOWER
FIGURE 3
FIGURE 4
SET-UP INSTRUCTIONS (continued)
7. Route the deflector cable above the axle and in
front of the lower handle cross bar. Remove one of
the nuts and the boot from the end of the deflector
cable and install the cable through the key slot into
the bracket on the upper handle. Reconnect the
clevis from the control lever and install over the end
of the cable. Reconnect the clevis to the control
lever with a ¼ x 5/8 clevis pin and hairpin cotter.
(Note: The deflector can be moved and held in
place with the locking knob to help connect the
clevis fitting to the control lever. Move the control
lever to the rear to more easily connect the cable.
Loosen the knob so the deflector moves freely after
the clevis is connected. (Figure 3)
8. Move the deflector control lever to the rear of the
slot. Adjust the jam nuts on the cable fitting so
the deflector is completely closed. Lock the nuts
against the bracket when the adjustment is correct.
9. Secure the throttle and deflector cables to the
handle tubes with cable ties from the hardware
package. Trim off excess. (Figure 4)
10. Fill the engine with oil to the level indicated
on the dipstick. Fill the fuel tank with clean, fresh
regular grade unleaded gasoline.
SET-UP INSTRUCTIONS