Lanzar Car Audio 15 - Manual (Page 13)

11
M o u n t i n g a n d i n s t a l l a t i o n
(q y g y pp )
• Solder-less connectors or soldering gun with heat shrink tubing
1. Find a suitable location in the vehicle to mount the processor. The E-15 is a trunk mount unit and it should be installed in close proximity to your amplifier system.
You should pick a location that offers easy access to the unit for adjustment.
2. Before starting, disconnect the vehicle’s negative battery ground to prevent short circuits. Bolt the processor to the mounting surface, making sure there is sufficient
air flow around the installation.
3. There are three power terminals on the E-15.
• A red 18 gauge stranded or heavier and insulated wire should be connected to the terminal marked +12V. Wire an in-line fuse holder on this lead as it is the
12V DC wire for the system. This wire should be attached to the switched side of the vehicle’s ignition switch and should have power to it only when the vehicle
is running or the switch has been turned to the accessory position.
• A black stranded wire of at least 18 gauge should be connected to the terminal marked Ground. This is the ground wire for the E-15 and should be attached to
the same ground point with the amplifiers in the system. Keeping this ground wire as short as possible improves the electrical circuit and keeps ground-related
noise problems to a minimum.
• An orange stranded wire of a least 20 gauge should be connected to the terminal marked Remote. This wire connects to your head unit’s remote out or power
antenna lead out. This wire should supply 12 Volts DC any time the radio, CD or cassette are playing. This lead must also be connected to any other components
in your system that utilize a remote turn-on lead for powering up.
4. Connect all line inputs and outputs using high-quality RCA-RCA cables.
5. Recheck all connections before powering up.
6. Set all level controls to their least sensitive positions and set all crossover controls, switches, etc. to the desired frequency or position.
7. Once the system is powered up, set the volume control on the head unit to about the 2 o'clock position, and then set all the amplifiers' level controls for maximum
output level.
8. Now you are ready to start equalizing your vehicle with the E-15.
Processor Installation