Lennox Hearth BT3030 - Manual (Page 7)

6
EN
g
Li
Sh
Jabra bT3030 blueTooTh headseT
Please note that the led indicator light turns off after  minute
to save battery . To check if the headset is on, tap the answer/end
button once – the led indicator light will flash, if the headset is on .
PAiRiNg yoUR hEAdSET WiTh yoUR PhoNE
headsets are connected to phones using a procedure called
‘pairing’ . by following a few simple steps, a phone can easily be
paired with a headset .
1. Put the headset in pairing mode
When you turn on your Jabra bT3030 for the first time, the headset
will automatically start up in pairing mode – i .e . it is discoverable
for your phone . When the headset is in pairing mode the led is
constantly lit with a blue light .
2. Set your Bluetooth phone to ‘discover’ the Jabra BT3030
follow your phone’s instruction guide . first make sure that
bluetooth is activated on your mobile phone . Then set your phone
to discover the headset . This usually involves going to a ‘setup,’
‘connect’ or ‘bluetooth’ menu on your phone and selecting the
option to ‘discover’ or ‘add’ a bluetooth device .* (see example from
a typical mobile phone in fig . ) .
3. Your phone will find the Jabra BT3030
your phone will find the headset under the name bT3030 . your
phone then asks if you want to pair with the headset . accept by
pressing ‘yes’ or ‘ok’ on the phone and confirm with the passkey
or PIn = 0000 (4 zeros) . your phone will confirm when pairing is
complete .
fig . 
Connectivity
MobilSurf
Bluetooth
Infrared port
WAP options
Synchronization
Networks
Select Info
Handsfree
Ok
JABRA BT3030
Added. The
handsfree is now
ready for use
Devices found
Select
JABRA BT3030
Ok
Passkey:
JABRA BT3030