Troubleshooting – Legacy Car Audio LA580 User Manual

Page 13

Advertising
background image

troubleshooting

Troubleshooting

2 CH Stereo plus
Mono-Bridged
Subwoofer Output

TROUBLESHOOTING

11

Amplifier will not power up.

• Check for good ground connection.
• Check that remote DC terminal has at least +12v DC.
• Check that there is battery power on the + terminal.
• Check all fuses.
• Check that Protection LED is not lit. If it is lit, shut off amplifier
briefly and then repower it.

High hiss or engine noise (alternator whine) in
speakers.

• Disconnect all RCA inputs to the amplifier(s) – if hiss/noise
disappears, then plug in the component driving the amplifier
and unplug its inputs. If hiss/noise disappears, go on until the
faulty/noisy component is found.

• It is best to set the amplifier's input level as insensitive as
possible. The best subjective S/N ratio is obtainable this way.
Try to drive as high a signal level from the head unit as possible.

Protection LED comes on when the amplifier is
powered up.

• Check for shorts on speaker leads.
• Check that the volume control on the head unit is turned
down low.
• Remove speaker leads, and reset the amplifier. If the
Protection LED still comes on, then the amplifier is faulty.

Amplifier(s) gets very hot.

• Check that the minimum speaker impedance for that model
is correct.
• Check for speaker shorts.
• Check that there is good airflow around the amplifier. In
some applications, an external cooling fan may be required.

Distorted sound

• Check that the Level control(s) is set to match the signal
level of the head unit.
• Check that all crossover frequencies are properly set.
• Check for shorts on the speaker leads.

High squeal noise from speakers.

• This is almost always caused by a poorly-grounded RCA
patch cord.

Before removing your amplifier, refer to the list below
and follow the suggested procedures. Always test the

speakers and their wires first.

speakers

MINIMUM

SPEAKER

IMPEDANCE

4 OHMS!

4CH AMPS

LA

680

LA

1080

GND

REM

FU SE

12

V

GND

REM

FUSE

12

V

CH

4

BRIDGED

GND

GND

REM

REM

FU

U

SE

FUSE

12

V

12

V

CH

4

CH

4

+

CH

2

+

CH

1

+

CH

3

+

BRIDGED

+

BRIDGED

BRIDGED

+

L

Mono

Subwoofer

R

Advertising
This manual is related to the following products: