Palsonic PMC-191 - Manual (Page 4)

TRACK NO.
RANDOM
INDICATOR
PROGRAM
INDICATOR
General Operation
MIN SEC
PLAY / PAUSE Button
STOP Button
SKIP Buttons
RANDOM Button (at Remote)
Press once to start play, press once again to stop the || disc play
temporarily. When CD player is paused, display is blinking.
Press to stop play.
Press once to skip to next track | or back to previous track
| UP/ | and DOWN / |
Press once, the display will show a "Random".
Press the Play button to play the disc in random order. When CD
is playing in Random mode, press UP / | to select another track
randomly.
Press the Random button again to terminate the Random display.
During CD Play Random Play is started by pressing the RANDOM button once.
To obtain optimum sound performance for CD, select the switch at the back to CD position.
Program Play (For CD only) by Remote
Up to 20 tracks can be programmed for disc play in any order. Before use, be sure to press the Stop button.
PROGRAM NO. STATION NO.
Set in CD mode.
Press the MEMORY button (at remote), the display will show blinking "Track" and "Memory".
Moreover, it will indicate program no. and digits for track no. to be programmed.
Select a desired track by using the Skip buttons.
Press the MEMORY button again to enter the track into the program.
Repeat steps 2 and 3 to enter additional memories into the program, if necessary.
When all the desired tracks have programmed, press PLAY / PAUSE button to play the disc in the
order you have programmed. The display will show the Program Indicator "MEMORY" to identify
this function.
Press STOP button to terminate program play.
Remarks: There are 5 seconds for memory writing enable state, after that the state would released
automatically.
Notes:
The program memory will be cleared when the Power button is set to "OFF", when CD mode is
changed to other modes, or when EJECT button is pressed.
During program play, press UP / | button to select the programmed track in order.
3
.
.
1.
2.
3.
4.
5.
6.
7.
.
1.
2.
REPEAT
INDICATOR