PYLE Audio PRJV66 - Manual (Page 5)

4
SPECIFICATONS
Power consumption: ....................................................... <220 W
Lamp power: .................................................................... 150 W
Color temperature: ......................................................... 9300 K
Lamp life: ....................................................................8000 Hrs
Power requirements: .......................................... 230 VAC/50 Hz
Running current: ................................................................. <2 A
Brightness: ................................................................. 1200 Lm
Resolution.......................................................800*600
Lens: ....................................................................f160mm/F=2.9
Contrast: ............................................................................800:1
Number of Pixels: .............................................................. 1.0 M
Color system: ............................................. NTSC/PAL/SECAM
Keystone-correction: ........................................................... 15
Max. advisable duration of usage: .............................. 24 Hrs
Projection picture size: ............................................ 50-100 inch
Dimensions: ..................................................310 255 95 mm
Weight: ............................................................................. 6 Kg
Specifications and design may be altered by the manufacturer
without any communication.
13
TROUBLE SHOOTING
Please refer to this chapter when you encounter a problem list prior to contacting your
dealer.
Problem: Possible solution(s):
No power Projector not connected to mains.
Projector not turned on.
Blown fuse.
Remote doesn't operate Projector turned on to quickly after last
turn off (needs 5 minutes).
Batteries defect.
Aim remote correctly at IR receiver.
No image Lens cap not removed.
Projector turned off.
Faulty wiring.
Selected the wrong input signal.
Projector turns off automatically Air in-and/or outlets and/or filter
(no more power) are covered or blocked.
Lamp doesn't function Power supply isn't correct.
Temperature is too high.
Defect lamp.
REPLACING THE LAMP
This lamp has a maximum lamp life. The color balance will change when the light intensity
decreases. The image will also blur. Replace the lamp if this is the case.
Turn the projector of and remove the power cord.
1. Place the projector on a cloth to put loose parts on.
2. Turn the screw loose and open the lid.
3. Remove the 4 screws holding the lamp unit. Pull the unit straight up.
4. Now replace the lamp and follow the steps (1-4) in opposite order to complete the
installation.