Mounting the ath1 transport – Planar A480-PL User Manual
Page 13
Planar A480-PL User Manual and Installation Guide, Version 2.3, copyright 2009, all rights reserved, Planar Inc.
Page 13
MOUNTING THE ATH1 TRANSPORT
1.
DO NOT CONNECT POWER TO THE TRANSPORT AT THIS TIME.
2.
Position the flat side of the
motorized transport against the bottom
side of the Attachment Plate so that the
transport logo is toward the screen and
the center “M” hole in the Attachment
Plate is aligned with the front recessed
transport hole. Insert the #10-32 pivot
screw up through the transport and
Attachment Plate and loosely complete
the assembly with the corresponding
washer, lock washer and nut. Now
loosely insert the four small
3/8” screws
through the
four remaining “M” slots through the top of the Attachment Plate and down into the
transport.
3. Refer to the ATH1 user manual (included with ATH1) for additional instructions to install the
lens at this time
, but do not forget to complete the “Final Adjustments” step below.
ATH1/M380 Attachment Bag Contents
#6-
32x3/8” screw (4)
#10-
32x5/8” screw (1)
#10-32 lock washer (1)
#10-32 washer (1)
#10-32 nut (1)
Pivot screw as
assembled
Attachment
Plate
ATH1 mount
M hole
M slots