Pioneer RM-V4000V User Manual
Page 61
60
<Giving IDs Using the Remote Control>
[1]
Enter the adjustment mode.
[2]
The main menu will be displayed. Press the
1
key.
Select ”1. ID CLEAR/SET/SELECT”
[3]
Check that the ID display at the top left of the screen is “– –” and press the
1
key.
Select “1.ID SET”.
If an ID has already been given, press the
0
key, select “0. ID CLEAR” of the main menu, return to “[1] Enter the
adjustment mode.” and give the ID.
[4]
As the ID input standby state is set, press the
0
to
9
,
A
to
F
keys, and input the ID.
[5]
To use the multi-screen unit, return to “[1] Enter the adjustment mode.” and given an ID to the next unit.
<Precautions for Giving IDs using the Remote Control and Personal Computer>
Communication cannot be performed with units connected using the ABL link cable, after units whose IDs have been
cleared. When the command “** IDC” shown in the figure on the previous page is performed, only the first unit can be
controlled. Using the command “11 IDS” will enable the 2nd unit and onwards to be controlled.
When IDs are set as this, the unit connected next can be controlled.
ADJUSTMENTS