Polk Audio DP-1 - Manual (Page 6)

www.polkaudio.com 6
There are two remotes included with the DP-1 CD/DVD player. The
large, black DR-3 is a unified system programmable/learning remote
control that has been pre-programmed to operate the most-often used
functions of both the Digital Solution preamp/processor and the DP-1
CD/DVD player. You can also program it to operate other components in
your system to reduce “remote clutter” on your coffee table. (See the
separate DR-3 Owner’s Manual for instructions on how to program and
use this remote for other devices.)
As nifty as it may be, the DR-3 unified remote cannot duplicate every
function of the DP-1 CD/DVD player or Digital Solution preamp/
processor without it turning into a nightmare of tiny buttons. For
control of the rarely used functions of the CD/DVD player and Digital
Solution preamp/processor, you’ll have to use their dedicated remotes,
the smaller DR-4, DR-1, or DR-2 remotes. If you can’t find them, look
under the sofa cushions; they’re probably there.
Notes on Batteries
• Do not leave dead or exhausted batteries in the remote control.
• Do not use different types of batteries together, or mix old and new
batteries.
• If you do not use the remote control for a long period of time, remove
the batteries to avoid possible damage from battery corrosion.
• Replace the batteries with new ones if the remote control does not
function correctly or if the operating range becomes reduced.
• If the batteries leak, wipe the battery liquid from the battery
compartment being careful not to get any on you, then insert
new batteries.
REMOTE CONTROLS
1
3
8
11
4
5
10
6
7
9
2
Status
Light