PYLE Audio PLCD69 - Manual (Page 8)

• SET THE CLOCK
Press the DSP button (15), and the
clock is shown on the display.
Then hold down the button until the
clock flashes. Then press the
MANU/SKIP button (17) to change
hours or MANU/SKIP button (16) to
change minutes.
• SELECT MODE
Press MOD button (6) to choose
desired listening mode.
(e.g. radio mode to CD mode to
AUX IN mode)
• SUBWOOFER
Press MOD button (6) for several
seconds to toggle subwoofer output.
When subwoofer on, display will show
“ SW”. Press it again for several
seconds to release this mode.
• MUTE
Press MUT button (2) to silence the
receiver. Press it again to release the
mode.
• LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (8).
• EQUALIZATION
Press EQ button (23) to turn on
equalization function and to select
desired audio mode. There are five
kinds of mode as below:
• AUXILIARY INPUT
The unit can be connected to a
portable audio player through the AUX
IN jack (7).
• REMOTE SENSOR
Point the remote control handset to
the remote sensor IR (26).
Press the function keys on the handset
to control the system.
• RESET
RESET button (25) must be activated
with either a ball point pen or thin metal
object. RESET button (25) is to be
activated for the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not
operate.
- Error symbol on the display.
Note: If press RESET button (25), the
unit can’t work yet, please use a cotton
swab soaked in isopropyl alcohol to
clean the socket on the back of the
front panel.
8
OPERATION
FLAT CLASSIC POP M ROCK M DSP OFF