Peavey KOSMOS V2 - Manual (Page 9)

9
Rear Panel
Subwoofer
This control sets the output level of the subwoofer signal, which is the sum of the
subharmonic output, the low frequency bass output, and the information from the 90 Hz cross-over net-
work (if not disabled by the crossover disable switch). When the bypass switch is engaged the
subwoofer is disabled.
Power
Depressing the power switch supplies power to the unit.
IEC Mains
Connect the supplied AC mains cord here. Make sure that the correct voltage is applied, or damage to
the unit could result. (See markings on unit.)
US DOMESTIC AC MAINS CORD:
The mains cord supplied with the unit is a heavy-duty, 3-conductor type with a conventional 120 VAC
plug with ground pin. If the outlet used does not have a ground pin, a suitable grounding adapter
should be used, and the third wire should be grounded properly.
Never remove or cut the ground pin of the line cord plug. The console is supplied with a properly rated
line cord. If lost or damaged, replace this cord with one of the proper rating.
NOTE FOR UK ONLY:
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings iden-
tifying terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be
connected to the terminal marked by the letter E, or by the earth symbol, or colored green or green and
yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter
N, or colored black. (3) The wire that is colored brown must be connected to the terminal that is marked
with the letter L or colored red.
Subwoofer Output
This 1/4” TRS electronically balanced output can be used in either balanced (with a 1/4” TRS jack) or un-
balanced (standard 1/4” jack) mode. The levels will automatically match the configuration. This output
supplies the signal for the subwoofer amplifier (line level).
Left and Right Outputs
The left and right outputs are electronically balanced, with pin 2 (and tip) positive. The XLR and 1/4”
TRS phono jacks are directly wired in parallel. They should not be used on the same channel at the same
time since the output balance would not necessarily be maintained, especially if a balanced and an
unbalanced connector were used.
Inputs
The left and right input jacks are balanced with pin 2 (and tip) positive. The XLR and 1/4” TRS jacks are
directly wired in parallel. Balanced or unbalanced inputs can be used. As mentioned above, do not use
both the XLR and the 1/4” inputs on the same channel at the same time or an imbalance could occur,
compromising the unit’s hum and noise rejection.
Mono
This switch converts the Kosmos® v2 to monophonic operation by selecting the left/mono input jack as
the source and routing it to both the left and right signal paths internally. The right input jacks are dis-
abled in this mode. Both the left and right outputs function, with only the high frequency stereo circuitry
causing a difference between them. When the unit is used as an insert effect, the switch should be set to
mono to operate properly.
11
13
14
15
12
11 12 13 14
15
9
10