Showing content with people+content ip – Polycom 9.0.6 User Manual
Page 21
Getting Started Guide for the VSX Series
© Polycom, Inc.
17
Showing Content with People+Content IP
To install the People+Content IP application on a computer:
1.
On a computer with Windows XP or Windows 2000, open a web browser
and go to the Polycom web site at
2.
Download and install the People+Content IP software.
To start showing content:
1.
On the computer, start the Polycom People+Content IP application.
2.
Enter the IP address or DNS name of your video conferencing system and
the meeting password, if one is set.
3.
Click Connect.
4.
Open the content you want to show.
5.
Do one of the following:
— Click
in People+Content IP.
— Press
Graphics on the video conferencing system’s remote
control.
To stop showing content:
1.
If the People+Content IP toolbar is minimized, maximize it by clicking
the icon in the task bar.
2.
Do one of the following:
— Click
in People+Content IP.
— Press
Graphics on the video conferencing system's remote
control.
If you have multiple content sources connected to your Polycom system and you
press Graphics on the remote control, you are prompted to select the content
source to use.
If the shared content disconnects after five minutes and you receive a dialog box
indicating that the five-minute People+Content IP demonstration has timed out, you
must contact your Polycom sales representative to purchase a key code to activate
the full version of People+Content IP on your system.
Points to note about People+Content IP:
•
People+Content IP provides video-only content. No audio is shared.
•
Only one computer at a time can be connected to a Polycom system.