Panasonic DIGA DMR-EZ47V - Manual (Page 77)

77
RQT8853
Ref
erence
Troubleshooting Guide
Use the following connection to suit the antenna lead to the unit’s RF IN terminal, and the 75  coaxial cable to the
antenna terminals on your TV or other equipment. Refer to the other equipment’s operating instructions for more
information.
If you connected this unit and a TV without an audio/video cable, interference (lines or patterning) or a very poor
picture may appear on the TV. If this happens, follow the steps below to change the video playback channel (RF
output channel) to remove the interference.
Type This unit Other equipment (television etc.)
A twin
lead
75−300  transformer
75  coaxial
cable
VHF or UHF
Television
from the antenna
(Flat) Twin lead
300
 cable
300−75  transformer
To this unit’s RF
IN terminal
TRACKING/V-LOCK
CH
to select “CH 3” or “CH 4”.
The unit’s display
Each time you press the button:
CH 3 (Default setting)
 CH 4  OFF

For connections with the audio/video cable, set the RF
output channel to “OFF”.
ENTER to fi nish.
RF Output Channel
Press the channel up/down buttons
to select a RF Output Channel.
Ch. 3
ENTER Press and hold
for more than
5 seconds.
– The RF output
channel number
displays on the
unit’s display.
Notes
When you set the RF output channel to “CH 3” or “CH 4”
Video from this unit can be viewed on channels 3 and 4 on the TV.
Press [VCR/TV] to switch to VCR mode and output video from this
unit (
¼ 6).
If the Antenna Connector Doesn’t Match
Changing RF Output Channel