Rear panel, Parts and their functions – Panasonic AJ-P User Manual
Page 12
12
PUSH
PUSH
AUDIO IN
(OPTION)
PUSH
PUSH
CH
1
CH
2
CH
3
CH
4
CH
1
CH
2
CH
3
CH
4
TC
HD/SD REF VIDEO IN
VIDEO OUT
IN
OUT
L
R
DC OUT
DC IN
SIGNAL
GND
FUSE 250V T2.5AH
F1
AC IN
12V 250mA
R
E
M
O
T
E
AUDIO OUT
(OPTION)
(OPTION)
75
Ω
ON
1
2
(SUPER)
Y/G
PB/B
PR/R
OFF
L
R
MONITOR
AUDIO
MON
OUT
1
2
3
4
5
6
7
=
=
8
?
<
;
9
:
>
Rear panel
Parts and their functions
1
AC IN inlet
This is the AC power inlet.
Connect the accessory power cable here.
When both an AC power supply and DC power
supply have been connected, the AC power supply
takes priority.
2
DC IN socket
This is the input connector for the DC 12V supply
voltage.
Use the optional AC adapter (AJ-B75 or AJ-B95).
When the voltage has dropped to around 10.6V, the
unit’s power is automatically turned off. (When
“TYPE-A” or “TYPE-B” is not selected as the menu
item No.180 [BATTERY SEL] setting)
Even when the supply voltage is restored later, the
power will not automatically come back on. The
POWER switch must be set to OFF and then back
to ON several seconds later.
When both AC power supply and DC power supply
are connected, the AC power supply takes priority.
3
DC OUT socket
This is the DC 12V output socket.
Power is supplied from here to the external remote
controller (AJ-A95).
The DC power cable is packed together with the
AJ-A95.
4
Fuse holder
This holds the AC 250 V/2.5 A fuse (time lag type).
<Note>
Use the fuse specified by Panasonic.
3
1
2
4
1
2
3
4
<Note>
Supplying +12V power to the GND terminal by mistake may give
rise to ignition, resulting in a fire, or it may cause injury.
Pin No.
1
2
3
4
Signal
Ground
–––
–––
+12 V
Pin No.
1
2
3
4
Signal
Ground
–––
–––
+12 V