Panasonic AJ-P - Manual (Page 37)

37
101 SHTL MAX
0000
0001
0002 X8.4
X16
X32
For setting the maximum speed in the shuttle mode when using the external
controller connected to the 9-pin remote connector.
0: 8.4k normal speed
1: 16k normal speed
2: 32k normal speed
<Note>
The maximum speed for the HD SP mode is automatically limited to 25k normal
speed.
102 FF.REW MAX
0000
0001
0002 X16
X32
X50
For setting the maximum speed of fast forward or rewind operations.
0: 16k normal speed
1: 32k normal speed
2: 50k normal speed
<Notes>
O The maximum speed for the DV and DVCAM modes is automatically limited to
32k normal speed.
O The maximum speed for the HD SP mode is automatically limited to 25k normal
speed.
104 REF ALARM
0000
0001 OFF
ON
For setting whether a warning is to be displayed when the REF VIDEO signal is not
connected.
0: No warning is displayed.
1: A warning is displayed by the flashing STOP lamp.
106 EJECT EE SEL
0000
0001
0002
EE
BLACK
GRAY
For setting the video and audio output statuses during eject.
0: Both the video and audio signals are always output in the E-E (electric
modulation to electric playback) mode regardless of the position of the TAPE/EE
switch.
1: The output status differs according to the position of the TAPE/EE switch.
EE: The signals are output in the E-E mode.
TAPE: BLACK is output for the video, and the audio is muted.
2: The output status differs according to the position of the TAPE/EE switch.
EE: The signals are output in the E-E mode.
TAPE: GRAY is output for the video, and the audio is muted.
<Note>
The EE pictures will be all black when the AJ-YA120AG (optional accessory) or AJ-
YAD120AG (optional accessory) is not installed.
OPERATION
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of settings
Setup menus
107 EE MODE SEL
0000
0001 NORMAL
THRU
For selecting the output signals in the EE mode.
0: Signals delayed by the time taken by internal signal processing are output.
1: Signal processing is not undertaken internally, and the signals are output
without delay at their original timing.
<Note>
The superimposed information is not displayed when THRU is used as the setting.
109 CAP LOCK
0000
0001
0002 2F
4F
8F
For selecting in how many field increments the playback framing is to be locked.
0: 2F
1: 4F
2: 8F
<Notes>
O 8F can be selected only when 50 is selected as the menu item No.25 [SYSTEM
FREQ] setting.
O In the HD LP or HD SP mode, the 2F mode is selected during recording 2 ,
including follow-on recording, and playback regardless of the menu item’s
setting.
108 PLAY DELAY 0000
:
0015
0
:
15
For setting the play rise time in frame increments.
“ ” indicates the factory setting.
2 This appears when the AJ-YA120AG (optional accessory) or AJ-YAD120AG (optional accessory) has been
installed.