Pioneer 50-Disc Magazine DRM-AF751 - Manual (Page 5)

5
<DRC1107>
English
En
TO INSTALL THE DISC MAGAZINE
Lock release Lock
Label
Guide
rails
Lock pin
Handle
For instructions on how to open the
a c c e s s d o o r s , s e e t h e o p e r a t i n g
instructions for the DRM-7000 disc
changer.
1. Insert discs into a disc magazine.
1 Turn the release knob to the vertical direction
to unlock.
2 Insert discs.
3 Turn the release knob to the horizontal
direction to lock the discs into place.
NOTES:
¶ Insert with label facing upward.
¶ Insert discs horizontally. Otherwise it may
result in damage to the discs.
¶ Take care not to scratch or do other damage
to the recording faces of discs.
¶ Do not turn a disc magazine upside down
while the lock is disengaged. Otherwise it
may result in discs falling out of the
magazine.
¶ Discs may not be inserted or removed when
the magazine is locked, and the use of
excessive force when trying to do so may
result in damage to discs or to the disc
magazine.
2. Insert magazine into changer.
Holding the handle of the disc magazine,
insert the disc magazine into the changer
following the changer guide rails until it
runs against the stopper.
And turn the handle to the left with
pushing the magazine in so that the lock
pin on the left of the magazine slides into
the corresponding hole along the side of
the changer.
Shown above is the insertion to the front
magazine bay. Though the insertion to the
rear magazine bay is almost same but note
that the proper installation position is in
the place where it is very secluded.
To remove a disc magazine from the
changer, pull the handle towards you and
pull the magazine from the changer.
Release knob
≠
Hole