Pride Mobility JAZZY 1103 - Manual (Page 26)

26 www.pridemobility.com Jazzy 1103 Ultra
V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from
the armrest, or change the position of the controller for ei-
ther left-hand or right-hand use.
WARNING! Do not place the controller
so that it can be pinched in the seat
framr or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 17.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the
rear shroud.
3. Unplug the controller connectors from the power pod.
4. Cut the wire tie(s) securing the controller cable to
the armrest.
5. Flip up the armrest and loosen the setscrew. See fig-
ure 17.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew in each armrest.
10. Use a wire tie to secure the controller cable to the
armrest.
11. Route the controller connector to the back of the power
base.
12. Plug the controller connectors into the power pod.
See figure 7.
13. Reinstall the rear shroud and tighten the fasteners.
Figure 17. Underside of Armrest
SETSCREW
CONTROLLER BRACKET