Panasonic AW-E300 User Manual
Page 47
-45-
%5
Color Matrix Compensation Level Setting
[Matrix (R-G) / (R-B) / (G-R) / (G-B) / (B-R) / (B-G):
–31 - +31]
Color Matrix compensation level can be adjusted.
(R-G):
To increase or decrease the intermediate
color between red and magenta
(R-B):
To increase or decrease the intermediate
color between red and yellow
(G-R):
To increase or decrease the intermediate
color between green and cyan
(G-B):
To increase or decrease yellowish green
(B-R):
To increase or decrease the intermediate
color between blue and cyan
(B-G):
To increase or decrease purple
%6
Gamma Correction Level Setting
[Gamma: 0.35 - 0.55]
Gamma correction level can be set.
%7
Knee Compensation Level Setting [Knee Point:
88 % - 98 % / DYNAMIC]
88 % - 98 %:
The level of video signals subject to
knee compensation (knee point) can be set.
Dynamic:
Knee compensation level is automatically
adjusted according to the scene.
%8
White Clip Level Setting [White Clip:
95 % - 110 %]
The peak level of video signals to be white-clipped
can be set.
%9
Flare Correction Level Setting [Flare R/G/B:
0 - 100]
Flare correction level can be adjusted.
* Flare correction level has already been adjusted
prior to shipment from the factory.
^0
Black Stretch Setting [Black Stretch: ON/OFF]
Black stretch to correct the suppression of black
portions at low luminance can be set to ON or OFF.
^1
Clean DNR Setting [Clean DNR: HIGH/LOW/OFF]
Clean DNR effect can be selected.
^2
PC Control Access Speed Setting [Baud Rate:
1 200bps/2 400bps/4 800bps/9 600bps]
This setting is to select a communication speed in
controlling the camera from the computer.
^3
Negative/Positive Selection [Nega/Posi:
Posi/ Nega]
Posi:
Normal image
Nega:
Image is shown reversed in darkness and
color.