Panasonic CQ-DFX572U - Manual (Page 26)

E
N
G
L
I
S
H
CQ-DFX572U
59
E
N
G
L
I
S
H
43
CQ-DFX572U
58
E
N
G
L
I
S
H
44
No. Item Q’ty
6 Power connector 1
Accessory used for wiring
Electrical Connections
❐ Wiring Diagram
Caution:
≥
This product is designed to operate with a 12 V DC, negative ground battery system.
≥ To prevent damage to the unit, be sure to follow the connection diagram below.
≥ Remove approximately 1 ⁄ 4 z (5 mm) of protective covering from the ends of the leads before connecting.
≥ Do not insert the power connector into the unit until the wiring is completed.
≥ Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables
and keep cable terminals free from touching any metal parts.
≥ Remember, if your car has a drive computer or a navigation computer, the data of its memory may be
erased when the battery terminals are disconnected.
Note:
≥
Not used.
External amplifier control lead
(Max. 500 mA)
This lead is for connection to the power amplifier.
ACC power lead
To ACC power, _12 V DC.
Battery lead
To the battery, continuous _12 V DC.
Ground lead
To a clean, bare metallic part of the car chassis.
(Blue/white stripe)
(Brown/white stripe)
(Dark blue)
(Red)
Registor (1 k≠)
(Yellow)
Fuse (15 A)
(Black)
+
-
(Violet)
(Violet/black stripe)
Right
REAR SP
+
-
Rear speaker lead (Green/black stripe)
(Green)
Left
+
-
(Gray)
(Gray/black stripe)
Right
+
-
Front speaker lead (White/black stripe)
(White)
Left
To front speaker
To rear speaker
6 Power connector
CQ-DFX572U
Antenna
CD changer control
connector
ACC
BATTERY 15 A
FRONT SP
S.W-OUT Monaural
(White)
(Red)
L (White)
R (Red)
L (White)
R (Red)
Subwoofer cord
AUX input cord
CD changer input cord
CD.C-IN
AUX-IN
Note:
≥ The power antenna extends automatically when the AM/FM
radio mode is selected.
Insulate this lead with vinyl tape.
Note:
≥
This lead is used for power control when an external power
amplifier is connected. The power supply of a power amplifier
will be activated when turning on the power of this unit.
Motor antenna relay control lead
(To motor antenna) (Max. 500 mA)
This lead is not intended for use with switch actuated power antenna.
L (White)
R (Red)
L (White)
R (Red)
Preout cord (Rear)
Preout cord (Front)
FRONT
REAR