Panasonic TX-47P600X - Manual (Page 26)

26
Sound System Selection (Different region use differing systems)
This function is used only in the TV mode when the sound is not clear or no sound is produced on a Programme
Number, and is not applicable in AV mode .
Press to select the “SOUND SYS”.
1
2
Press until the optimum sound is obtained.
SYS SELECT
CH SELECT
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS 6. 0MHz
COLOUR SYS AUTO
OFF
JAPAN
POSITION
TUNING MENU
Sound System Condition.
Note:
These are different sound broadcast transmission systems applicable to differing countries.
The sound system will change as shown.
4.5MHz
6.5MHz
5.5MHz
6.0MHz
Press to store the Sound System.
STR
Tuning Channels
Colour System Selection (Different region use differing systems)
If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, this function is used.
Colour System Condition.
Note:
PAL, SECAM and NTSC 3.58 are different colour signal broadcast transmission systems applicable to differing countries.
NTSC 4.43 is a trick playback mode used in special VCR to playback NTSC recorded video tapes through PAL
television equipment.
This returns the set to the normal viewing condition.
2
Press to exit from the “COLOUR SYS”.
TV/AV
SYS SELECT
CH SELECT
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS 6. 0MHz
COLOUR SYS AUTO
OFF
JAPAN
POSITION
TUNING MENU
AUTO PAL
NTSC3.58 NTSC4.43
SECAM
This returns the set to the normal viewing condition.
Press to exit from the “SOUND SYS”.
TV/AV
Press to store the Colour System.
STR
Press to select the “COLOUR SYS”.
1
Press to produce the optimum image.
The colour system will change as shown.