Panasonic C7301U - Manual (Page 8)

CQ-C8401U/C8301U/C7401U/C7301U
English
Power on
Press [SRC] (PWR: Power).
Note: The opening screen appears. You can overwrite
opening screen (moving image) with new one. (
a page
37)
Power off
Hold down [SRC] (PWR) until you hear a
beep, then release it.
Note: The ending screen appears. You can change the
ending screen (moving image). (
a page 37)
14
General
This chapter explains how to turn on or off the power, how to adjust the volume, etc.
CQ-C8401U/C8301U/C7401U/C7301U 15
You can remove the face
plate to prevent it from
being stolen.
Removing
1
Turn off the power ( a page 14)
2
Press [ ]
(Release).
(The face plate disen-
gages with a click
when it is removed.)
The face plate automatically closes after a lapse of 5
seconds while it is open.
The power is automatically turned off while the unit
is active.
3
Put the face
plate in the case.
Mounting
1
Slide the left side of the face plate in
place.
2
Press the right end of the face plate
until “click” is heard.
Cautions:
¡ It is recommended to remove or mount the face
plate when the plate is at the closed position.
Do not remove or mount the face plate when the
plate is in motion.
¡ This face plate is not waterproof. Do not expose it to
water or excessive moisture.
¡ Do not remove the face plate while driving your car.
¡ Do not place the face plate on the dashboard or
nearby areas where the temperature rises to high
levels.
¡ Do not touch the contacts on the face plate or on the
main unit, since this may result in poor electrical
contacts.
¡ If dirt or other foreign substances get on the con-
tacts, wipe them off with clean and dry cloth.
¡ To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
Open/Eject
Press [ ] (OPEN).
When a disc is already loaded, the disc will automatically
be ejected.
Close
Press [ ] (OPEN).
Tilt
The display angle changes among 4 levels as follows
every time you hold down [
] (TILT) for 1 sec. or
more and release.
Note: The last selected
angle is memorized even
after turning off the power.
Notes:
¡ The volume level can be set independently for each
source. (For radio, one volume setting for AM, one
volume setting for all FMs)
¡ The volume is not adjustable while an error display is
on the monitor. (
a page 42)
q Up
w Down
Setting Range: 0 to 40
Default: 18
Volume off (down)
Press [ ] (MUTE).
Cancel
Press [ ] (MUTE) again.
Note: Volume-down range can be specified. ( a page
35)
SRC CQ-C8401U SRC
CQ-C8401U
SRC CQ-C8401U
SRC CQ-C8401U
General
Power On/off
(PWR: Power)
Face Plate Motion (Open/Close, T
ilt)
(OPEN/CLOSE, TILT)
V
olume Adjustment
(VOLUME)
Temporar
y V
olume Off (Down)
MUTE (ATT: Attenuation)
Cautions:
¡ To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
¡ Do not pinch your finger or hand in the face plate.
¡ Do not insert foreign objects into the disc slots.
¡ For the following cases, the face plate automatical-
ly closes. Use caution not to catch your finger.
¡ After a lapse of 20 seconds
¡ When a disc is inserted
¡ When the face plate is removed ( a page 14)
TILT 1
TILT 2
TILT 3
OPEN
TILT OFF
Face Plate Removing/Mounting
(Anti-Theft System)