Prince Castle 428 - Manual (Page 2)

INTENDED USE
This toaster is designed to toast breads bagels or
English muffins.Do not attempt to toast croissants.
Their butter content will cause them to stick to the
conveyor. Do not attempt to toast products that have
been buttered or spread with jam or other coating.
Do not attempt to bake in the toaster.
INSTALLATION
1. After you have removed the toaster from the
carton, inspect the unit for signs of damage. If
there is damage to the unit:
l Notify carrier within 24 hours after delivery.
l Save carton and packing materials for inspection
purposes.
l Contact your local dealer or, if purchased di-
rectly, the Prince Castle Customer Sales Depart-
ment at 1-630-462-8800 to arrange for a replace-
ment to be sent.
2. Verify that all parts have been received. Remove
Protective Coating.
3. Attach four (4) legs to toaster by screwing in
each leg clockwise.
4. Adjust legs so toaster is level.
5. Remove packaging from bun slide and install bun
slide in toaster by hooking it into the two pins in
the rear of the chamber. (See Detail 1)
6. Attach heat shield by hooking its top tabs onto
the two mounting pins just under the crumb tray
then allow the shield to swing down so it touches
the two lower mounting pins. Lift shield slightly
to hook onto the lower pins. Attach the product
slide tray by hooking its tabs onto the two
uppper mounting pins at the top front of the
toaster. (See Detail 2)
2
OPERATION
1. Plug unit into the proper voltage receptacle.
2. Set Power switch to “l” for On.
3. Turn upper and lower heater controls to maxi-
mum.
4. Allow 20 minutes for toaster to warm up.
5. Lay Bread, Bagel or Muffin, cut side up on the
inlet ramp and push into toaster until it slides on
to the conveyor chain. To control toast color,
vary the conveyor speed or the heater settings.
PREVENTIVE MAINTENANCE
1. The toaster is cooled using air flowing through
the electrical areas. DO NOT operate the toaster
without either side cover or the rear cover.
2. The conveyor chain should not touch the top
surface of the crumb tray holder. If the chain
does touch, retension it by unplugging the unit,
remove both side covers, loosen the front bearing
mounting screws and pivot the bearing until the
chain no longer touches. Re-tighten bearing
screws and replace side covers.
3. The toaster has an internal high temperature
switch. If internal temperature becomes too hot
the switch will shut off power to the top heaters.
The switch will reset automatically once the
toaster has cooled.
7. The toaster fan located on the bottom of the
toaster in the rear draws in cool room air and
circulates it through the toaster sides and tops.
To insure adequate heat dissipation do not posi-
tion the toaster where the fan would draw in hot
discharge from another appliance.