Panasonic PV-V4622 - Manual (Page 10)

10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Initial Setup for DSS/Cable Box
➛ ➛ ➛ ➛ ➛ VCR ➛ ➛ ➛ ➛ ➛ TV Connection
Connect the OUT Jack on your cable box to the IN FROM ANT.
terminal on the VCR with the RF Cable.
Connect the OUT TO TV terminal on the rear of VCR to the ANT.
IN terminal on TV using the RF Cable (included accessory).
2
1
Please make all cable or antenna connections before plugging into the AC outlet.
Plugging the VCR Power Cord into an AC wall outlet starts auto channel and clock set.
2
IN FROM ANT. TV
VCR
VHF/UHF
OUT TO TV
IN from
ANT./CABLE
Cable TV
Converter Box
1
Turn TV on and tune to channel 3.
Plug VCR Power Cord into AC wall
outlet. VCR comes on and auto
channel and clock set starts.
• If screen at right does not appear,
check VCR - TV connection and, if
TV is tuned to channel 3, try
switching it to channel 4.
• To change VCR’s output channel,
please refer to “VCR’s Output
Channel” on page 13.
1
2
CH AUTO SET PROCEEDING
CANCEL : STOP
Plugging the AC Power Plug into an AC outlet
How to Connect
Doing Initial Setup (Ready to Play)
• Turn on your cable box and set it to
your Public Broadcasting Station (PBS)
channel in your time zone. If you use a
DSS receiver, it must be turned off.
WARNING
When using “Nut type” RF coaxial cables,
tighten with fingers only. Overtightening may
damage terminals.
AUTO CLOCK SET
PROCEEDING
CANCEL : STOP
V4622 P1-21 (2nd) [LSQT0509B].p65 2002/05/23, 18:28 10