Other functions adjusting initial settings, Setting the clock, Switching the auxiliary setting – Pioneer DEH-P3900MP User Manual
Page 34: Setting the rear output and subwoofer, Output, Adjusting initial settings, Setting the rear output and subwoofer output, Other functions
Adjusting initial settings
1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1
Press SOURCE and hold until the unit
turns off.
2
Press SOURCE and hold again until
function name appears in the display.
3
Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION repeatedly to switch be-
tween the following settings:
Clock
—AUX1 (auxiliary input 1)—AUX2 (aux-
iliary input 2)
—R-SP (rear output and subwoo-
fer controller)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down
SOURCE until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1
Press FUNCTION to select clock.
2
Press c or d to select the segment of
the clock display you wish to set.
Hour
—Minute
As you select segments of the clock display
the segment selected will blink.
3
Press a or b to set the clock.
Pressing a will increase the selected hour or
minute. Pressing b will decrease the selected
hour or minute.
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on the next page.
1
Press FUNCTION to select AUX1/AUX2.
2
Press a or b to turn AUX1/AUX2 on or
off.
Setting the rear output and
subwoofer output
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
R-SP :FUL) or subwoofer
(
R-SP :S/W) connection. If you switch the rear
output setting to
R-SP :S/W, you can connect
a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
1
Press FUNCTION to select R-SP.
2
Press a or b to switch the rear output
setting.
Pressing a or b will switch between
R-SP :FUL (full-range speaker) and R-SP :S/W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select
R-SP :FUL.
Other Functions
En
34
Section
10