Pride Mobility Jet 3 Ultra - Manual (Page 4)

What if the speed LEDs on the VSI begin to flash?
! Determine if the battery charger is connected to the power base. When the battery charger is connected to
the power base, a charger inhibit feature keeps the power chair from driving. This is indicated by the VSI speed
LED(s) flashing.
! Determine if the charger harness fuse has blown. A blown charger fuse can cause the charger inhibit to
activate.
! Determine if all controller connections are plugged into the power base properly. If the 3-pin charger
inhibit connector is not plugged in properly, then the charger inhibit feature will activate.
What if the speed LEDs on the VSI begin to scroll?
! Determine if the VSI has been placed in lock mode. The VSI is equipped with a lock mode feature that
prevents unintended use of the power chair. If the VSI is in lock mode, deflect the joystick full forward until it
beeps, and then deflect the joystick full rearward until it beeps. The joystick should go back to the drive function.
B
ASIC
T
ROUBLESHOOTING
I
NSTRUCTIONS
: J
ET
3 U
LTRA
INFINFB2045/Rev A/12-04-06 www.pridemobility.com 4