Panasonic KX-TG5456 - Manual (Page 42)

Programmable Settings
42 For assistance, please visit http://www.panasonic.com/consumersupport
may not work correctly. Consult your
PBX supplier for the correct setting.
Line mode
The line mode is preset to “B” and
generally should not be adjusted. If
S on the handset is not displayed
properly when another phone connected
to the same line is in use, the line mode
selection is incorrect. Set line mode to “A”.
1
Press {MENU} (middle soft key).
2
Scroll to N, then press {SELECT}.
3
Scroll to “Set tel line”, then press
{SELECT}.
4
Scroll to “Set line mode”, then press
{SELECT}.
5
Press {V} or {^} repeatedly to select
the desired setting.
6
Press {SAVE}, then press {OFF}.
Base unit settings
Base unit ringer volume
4 levels (high/medium/low/off) are
available.
Important:
L Make sure the base unit is not being
used.
Press {<} or {>} repeatedly to select the
desired volume.
L To stop ringing, press {STOP}.
To turn the ringer off, press and hold {<}
until the unit beeps 2 times.
L
O
will be displayed.
Base unit ringer tone
This feature must be set by using the
handset.
1
Press {MENU} (middle soft key).
2
Scroll to N, then press {SELECT}.
3
Scroll to “Set base unit”, then press
{SELECT}.
4
Scroll to “Ringer tone”, then press
{SELECT}.
5
Press {V} or {^} repeatedly to select
the desired setting.
L If the ringer volume has been turned
off, the base unit will not ring.
6
Press {SAVE}, then press {OFF}.
Base unit interrupt tone
This tone lets you know when you receive
a call while you are on an intercom call.
“2”: The tone will sound 2 times.
“On”: The tone will sound for as long as the
line rings.
“Off”: Turns this feature off.
This feature must be set by using the
handset.