PUR Water Purification Products Water Cooler PUR300 - Manual (Page 3)

1
ENGLISH
1
ENGLISH
1
Table of Contents
Safety Precautions
Unpacking and Parts
Setting Up Your Water Cooler
Pre-activating & Installing the Filter System
How to Monitor Filter Life
Key Features
Proper Care and Cleaning
Storing Unit
Frequently Asked Questions
Troubleshooting
Warranty
Technical Specifications
Performance Data Sheet
Safety Precautions
READ ALL OF THE INSTRUCTIONS BEFORE USE:
1. This water filtration system is designed for INDOOR USE ONLY and should not be used
outdoors.
2. Use this system only for its intended purpose as described in this use and care guide.
3. Install system on a firm level floor away from radiators..
4. Allow the system to stand in an upright position for at least 30 minutes before turning
on the power to allow all cooling refrigerant to settle.
5. Allow at least 1" of space for ventilation around the sides of the unit for air circulation
and electrical connections. Do not recess or build into an enclosed cabinet.
6. Close supervision is necessary when system is used by or near children.
7. Do not plug in unit until system is completely assembled and filled with water. Unplug
your water cooler before cleaning.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the
like. Arrange cord away from traffic area where it will not be tripped over.
This product is for use on 120 volts. The cord has a grounded plug. An adapter is
available at retail (not included) for connecting three blade grounding-type plugs to
two-slot receptacles. The green grounding lug extending from the adapter must be
connected to a permanent ground such as a properly grounded outlet box. The adapter
should not be used if a three-slot grounded receptacle is available.
This product draws 450 watts during operation. To prevent overloading a circuit, do not
plug the product into a circuit that already has other appliances working.
It is normal for the plug to feel warm to the touch; however, a loose fit between the
AC outlet (receptacle) and plug may cause overheating and distortion of the plug.
Contact a qualified electrician to replace loose or worn outlet.
To disconnect the product, first turn controls to the OFF position, then grip the plug
and pull it from the wall outlet. Never pull by the cord.
9. Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. Systems that are certified for cyst
reduction may be used on disinfected water that may contain filterable cysts.
Individuals requiring water of specific microbiological purity should consult their
physician.
SAVE THESE INSTRUCTIONS for future use.