Pioneer VSX-1014TX - Manual (Page 69)

Additional information 12
69
En
Remote control
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Symptom Cause Remedy
Cannot be remote controlled. • The remote control batteries have worn out. • Replace the batteries (see Loading the batteries on
page 7).
• Too far away or improper angle of operation. • Operate within 23 feet and a 30º angle of the remote
sensor on the front panel (see Operating range of remote
control unit on page 29).
• There is an obstacle between the receiver
and the remote control. • Remove the obstacle or move to another place.
• Strong light such as fluorescent light is
shining onto the unit's remote control sensor. • Avoid exposing the remote sensor on the front panel to
direct light.
• Something is plugged into the CONTROL IN
jack.
• Unplug the cable from the CONTROL IN jack and use
remote normally (see Operating other Pioneer components
on page 22).
Other components can't be
operated with the system
remote. • The preset code settings are wrong.
• The batteries wore out and the system
settings were cleared. • Input the correct preset code.
• Reset the proper system settings.
The SR cable is connected, but
the connected components can’t
be operated with the remote. • The SR cable hasn't been connected
properly. • Reinsert the SR cable, making sure it’s connected to the
right jack (see
Operating other Pioneer components on
page 22).
• The rest of the component connections
have not been made. • Make sure an analog connection has been made
between the units.
• The component you have hooked up is not a
Pioneer product. • This feature only works with Pioneer products.
VSX_1014.book.fm 69 ページ ２００４年５月１４日 金曜日 午前９時２４分