Peripheral Electronics SIMPLE PGHGM3 - Manual (Page 11)

8
11. Warranty Information
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your
satisfaction. This warranty applies only to the original purchaser of this prod-
uct from an authorized Peripheral Elecronics dealer. This warranty covers any
supplied or manufactured parts of this product that, upon inspection by Pe-
ripheral Electronics authorized personnel, is found to have failed in normal
use due to defects in material or workmanship. This warranty does not ap-
ply to installation expenses. Attempting to service or modify this unit, operat-
ing this unit under conditions other than the recommended voltage will render this
WARRANTY VOID.
Unless otherwise prescribed by law, Peripheral Electronics shall not be liable for
any personal injury, property damage and or any incidental or consequential dam-
ages of any kind (including water damage) resulting from malfunctions, defects,
misuse, improper installation or alteration of this product. All parts of this Periph-
eral Electronics product are guaranteed for a period of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above,
Peripheral Electronics will repair or replace the product at their discretion, if it
is defective in material or workmanship providing it is returned to an Authorized
Peripheral Electronic’s Dealer, with PROOF OF PURCHASE from an authorized
Peripheral Elecronics dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during op-
eration. Exposure to direct sunlight or extreme heat may cause damage or mal-
function.
FCC Class B Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful in-
terference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television recption, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
1. Reorientate or relocate the receiving antenna.
2. Increase the separation between the equipment and reciever.
3. Connect the equipment into an outlet on a circuit differant from
that of which the reciever is connected.
4. Consult the dealer or an experienced radio / television technical
for help.
Notice : The changes or modifications not expressly approved by the party re-
sponsible for compliance could void the user authority to operate the equipment.
For Best Performance Have It
Professionally Installed.