Planet Technology MGSW-004 User Manual
Page 9
5
Desktop installation
For desktop installation, make sure the desk is flat and clean. Plug all the network cables and
the power cord then the system is ready.
Note:
Do not obstruct any vents at the sides of the case and keep water off.
Rock-mount installation
MGSW-004 can be mounted in a standard 19-inch rack. The following steps is teaching user
how to Rack Mounting the Switch in the 19-inch rack:
1.
Disconnect all cables from the switch.
2.
Place the unit the right way up on a hard, flat surface with the front facing toward
you.
3.
Locate a mounting bracket over the mounting holes on one side of the unit.
4.
Insert the screws and fully tighten with a suitable screwdriver.
5.
Repeat the two previous steps for the other side of the unit.
6.
Insert the unit into the 19" rack and secure with suitable screws (not provided).
7.
Reconnect all cables.
Module installation
The slot on the font panel is purposed for installing optional modules. Following steps is
described how to install a module.
1.
Power off the switch.
2.
Removing the two screws on the faceplate of slot with a flat-head screwdriver.
3.
Push the module gently into the slot along the slide tracks.
4.
Ensuring that it firmly engages with the connector then tighten the screws to secure
the module.