Pella Clad Hinged patio Door With Adjustable HInges 80JJ0103 - Manual (Page 5)

A. Apply side flashing tape. Cut two
pieces of flashing tape 4" longer than
the frame height of the door. Apply one
piece 1/2" onto the frame cladding,
OVER
SHOULD
DOOR
FOLDING
3
INTEGRATING THE DOOR TO
THE WATER RESISTIVE BARRIER
L. Check door operation. Open and close the door to check for proper operation. Make
sure the door will latch correctly.
Note: If there are any problems with the operation, recheck and
adjust the reveal.
M. Adjust the reveal if needed. The door panels have adjustable hinge
LEAFS
Note: DO NOT adjust the hinge with the top and bottom screws
loose; this could force the hinge to adjust beyond its design capability
which can cause the hinge to bind, damage the hinge and/or pull out
the screws. A 3/4 turn of the center screw provides approximately
1/16" adjustment.
N. On doors with a lock strike in the side,
PILOT

Note: This step does not apply to center latching double doors.
O. Install a #8 x 3" flat head stainless steel screw

&YUFSJPS
О

У
У
Note: The flashing tape must be applied approximately 1/2"
onto the frame cladding at the jambs and head. Pre-folding the
tape at 1/2" before removing the paper backing will make it
easier to apply the tape correctly. If the siding is less than 1/2"
thick, adjust the dimension of the fold so the exterior sealant
line will cover the exterior edge of the tape.