Polycom AVAYA 500D User Manual

Page 7

Advertising
background image

SoundStation Premier

Installation Instructions and User's Guide

8

SoundStation Premier

Installation Instructions and User's Guide

9

Your SoundStation Premier 550D can be

adapted to a larger conference room with

the addition of Extended Microphones.

If not purchased with your SoundStation

Premier 550D, these are available as an

accessory from your Polycom Distributor.
To mute all microphones from the

extended microphone, press

MUTE

.

To resume two-way communications,

press

MUTE

again. The red LED will

return to green.
An

ON/OFF

switch is located on each

of the extended microphones.

By switching to the O position, the LED

MUTE light will turn red and only this

microphone will be shut off. Switching

to the

1

position will turn the

microphone back on.

MUTE

Red LED

While the SoundStation Premier

500D/550D is not in use you may

use the DEFINITY phone (connected

to the 500D/550D Interface Module)

and it will function as usual.

Using the DEFINITY Phone

Incoming calls will ring on both the

DEFINITY phone and the SoundStation

Premier 500D/550D. If you answer the

call on the DEFINITY phone and want to

transfer it to the conference phone, simply

press

ON/OFF

on the conference phone

and hang up the handset. The LED's will

blink red to indicate the mute condition

until the handset is returned to the cradle,

then return to the green steady state.

The call will be active on the conference

phone and all functions will be as defined

for calls initiated on the conference phone.

Calls Answered On the DEFINITY Phone

Conference calls already established

on the DEFINITY phone can be easily

transferred to the SoundStation Premier

500D/550D by pressing the

ON/OFF

button on the conference phone then

replacing the handset. The LED's will

blink red to indicate the mute condition

until the handset is returned to the cradle,

then return to the green steady state.

The 500D/550D will function as if the

conference call had originated on the

conference phone. If the ECS limit has

not been reached, new parties may be

added or dropped as described earlier.

Caution: Transferring conferences before

the cycle is complete, i.e. before the call

is established, and included or dropped,

will result in dropping all callers if you

subsequently push the

ON/OFF

button

on the conference phone.

Conferences Established On the DEFINITY Phone

If you have a DEFINITY phone

connected to the Interface Module, and

your SoundStation Premier 500D/550D

is in use, you may use your phone to

break away from the public conference

call to speak privately to the far end(s)

without disconnecting the conference call.

When you lift the handset, all microphones

and the speaker on the console are muted.

The red LED’s will blink to indicate

the mute condition. When the handset

is returned to the cradle, the conference

call is resumed and the LED’s return to

a steady state.

Mute Initiated By the DEFINITY Phone

Using Extended Microphones

Check with your network administrator

if you are unsure about the conferencing

services provided.
CAUTION: Once added to the conference,

calls cannot be selectivey dropped without

terminating the conference call.

Take care to terminate unwanted

calls - busy tone, voicemail, a person

otherwise occupied - by pressing

ON/OFF

before pressing

CONF

to begin the next attempt. Far end

participants may hang up at any time.

Check that all connections are

correct and tight.

Confirm that you are connected to

a DEFINITY digital voice jack.

Disconnect and reconnect all

cables in order as described in

the installation instructions.

No Dial Tone

In Case of Difficulty

Ringer volume is set at OFF.

Reset according to instructions.

The SoundStation Premier 500D/550D Console Does Not Ring

Do not move the SoundStation Premier

500D/550D console while it is in use.

Keep your hands away from

the console during calls.

Keep papers, cups, coffee pots, etc.,

away from the console.

At the beginning of a call, let someone

at each location speak in turn for a few

moments, to enable the system to adapt

to its environment.

The other party may be using

lower-quality equipment or a

half-duplex conference bridge,

in which case there may be little

you can do to improve performance.

Try calling again to see if another

line provides a better connection.

Short Silences, Echoes, or Clipped Speech

Advertising
This manual is related to the following products: