Panasonic KX-THA14 - Manual (Page 14)

Connecting to the Base Unit or to another Computer
14 For assistance, please visit http://www.panasonic.com/phonehelp
Registering the USB
adaptor
Before you use the USB adaptor you must
first register it to the base unit, another
USB adaptor, or another Bluetooth device.
1
Your computer:
Connect the USB adaptor to your
computer.
L
The MULTI TALK V USB Utility starts.
If the software does not start, refer to
the troubleshooting section (page
18).
2
Click the Data Link Manager icon in the
MULTI TALK V USB Utility-Main Menu
window.
L Data Link Manager window is open.
3
Click [Find Device].
L
All connectable devices are listed in
the Device List.
L A maximum of 10 devices can be
found.
4
Select the device you would like to
connect to, then click [Find Service].
L
All available services are listed in the
Service List.
L
When you connect to another
computer’s USB adaptor or a
Bluetooth device, skip to step 6.
5
Base unit:
Press and hold {INTERCOM} until it
starts flashing and a beep sounds.
L After {INTERCOM} starts flashing,
the rest of the procedure must be
completed within 2 minutes.
6
Your computer:
Select the desired service, then click
[Connect].
7
Enter the device’s PIN. (Refer to the
operating instructions provided with the
device.)
L
When you access to the base unit or
another USB adaptor, enter the
current 4-digit PIN (default: “7262”).
L
Depending on the Bluetooth device,
the PIN for the device is not required.
8
Click [OK].
L
The animation in the lower left corner
of the Data Link Manager screen
indicates that the connection is
established.
L
If you close the Data Link Manager
window, the current connection is
disconnected.
Note:
L The screen shots in these instructions
are for Windows XP and are included for
reference only.
L
The screen shots in these instructions
may differ slightly from the screen
shown on your computer.
THA14(e).book Page 14 Tuesday, March 7, 2006 5:31 PM