Panasonic PT-L702SDE - Manual (Page 13)

13
Capturing images
Using the FREEZE button Using the MAIN MENU
Insert the SD memory card into the projector according to
the procedure given on page
10 .
# # # # #
Project the screen image to be captured.
Use the input select (INPUT, RGB, VIDEO) button to select the input
signal, or operate the signal source (such as the computer or VCR) to
project the screen image to be captured.
$ $ $ $ $
Press the FREEZE button on the
remote control. % % % % % Press the MENU button to
display the MAIN MENU screen.
If the image being projected is okay
as it is, press the FREEZE button.
A confirmation screen will be
displayed. Use the I or H arrow
button to select "YES", and then
press the ENTER button.
If the confirmation screen does not
appear, make the setting described
on page
12 .
& & & & & Use the F F F F F or G G G G G arrow button to
select "CAPTURE", and then
press the ENTER button.
M E N U
K E Y S T O N E
P I C T U R E
P O S I T I O N
I N D E X W I N D O W
S H U T T E R
A U D I O
L A N G U A G E
O P T I O N
S D C A R D
C A P T U R E
S E L C T E N T E R
Capturing will then start, so wait
until it is complete (approx. 30
seconds [for a RGB signal]).
When capturing is complete, the direc-
tory number and file number for the
saving location of the captured image
will be displayed as shown at right.
( ( ( ( (
Press the MENU button to end the capture procedure.
To capture another image, repeat the procedure from step $.
) ) ) ) )
Note:
B If there is not enough free space on the SD memory card, "CARD FULL"
or "ERROR" will be displayed.You can either delete unwanted images by
following the steps given on page
30 , or you can insert another SD
memory card which has sufficient free space available.
B If the write-protect switch of the SD memory card is set to the LOCK position,
"WRITE PROTECTED" will be displayed.Remove the SD memory card from the
projector and move the write protect switch from the LOCK position to continue.
B If the SD memory card is removed before the capturing operation is
complete, it may result in loss of data on the card.
F I L E N A M E I S
1 0 0 - 0 0 6 8
R E S T 2 . 0 M B
Freespace on SD memory
card
Directory number-
Filenumber