Paradyne U8777 - Manual (Page 34)

3. Initial Startup and Configuration
3-12 May 2002 8700-A2-GB20-40
Downloading Firmware
The Download Code screen allows you to download firmware from a TFTP server
or MCP FFS. To access the Download Code screen, follow this menu selection
sequence:
Main Menu
→
Control
→
Download Code
Procedure
To download firmware:
1. Position the cursor in the Image File Name field. Type the name of the file to
be downloaded.
The file name may be a regular path name expression of directory names
separated by a forward slash (/) ending with the file name. The total path
name length can be up to 128 characters.
2. Position the cursor in the TFTP Server IP Address field. Enter the TFTP server
IP address or M1 for the MCP FFS.
3. For an LTU, go to Step 4 . For an NTU, position the cursor in the Destination
field. Use the spacebar to select a network destination for the TFTP server.
Select one of the following:
— DSL if the TFTP server destination is the EOC.
— IMC if the TFTP destination is via the MCP.
4. Position the cursor in the Immediately Apply Download field. If you would like
the download to be effective immediately, select Yes.
main/control/download_code
Slot: 4 Model: 87xx
Port: 1
DOWNLOAD CODE
Image File Name: Clear
TFTP Server IP Address: IP 000.000.000.000 Clear
Destination: DSL
Immediately Apply Download: Yes
Start Transfer: No
Packets Sent: 0000000
Packets Received: 0000000
Bytes Sent: 0000000
Bytes Received: 0000000
Transfer Status: Transfer Pending
-------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit