Pioneer A-A9-J - Manual (Page 11)

Controls and displays 03
11
En
English
Français
Deutsch
Nederlands
Italiano
Español
Remote control
1 
Switches the amplifier between standby and
on.
2 VOL +/–
Use to set the listening volume.
3 MUTE
Mutes/unmutes the sound.
4 S. RETRIEVER
Press to switch the Sound Retriever on/off
(page 12).
5 DIMMER
Dims or brightens the display (or switches the
backlight off).
6 Input selector buttons
Press to select an input source. These select
the component connected to the
corresponding input on the rear panel.
7 TONE/BAL controls
Use to adjust the tone and balance (page 12).
8 DIRECT
Press to access Direct listening (page 12).
Using the remote control
Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• The remote has a range of about 7 m at an
angle of about 30º from the remote sensor.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
• Replace the batteries when you notice a
fall off in the operating range of the remote.
Display
1 Tone control indicators
TREBLE – Lights when high-range tone
adjustment is applied.
BASS – Lights when low-range tone
adjustment is applied.
2 Sound Retriever indicator
Lights when the Sound Retriever function is
enabled.
3 Master volume level
4 Character display
Displays various system information.
INTEGRATED AMPLIFIER
DIMMER
TAPE
TUNER
AUX USB
VOL
MUTE
CD
PHONO
TONE/BAL
L / R /
S.RETRIEVER
DIRECT
1
2
3
4
5
6
7
8
TREBLE TREBLE
BASS BASS
dB dB
3
4
1 2
A9_MY.book Page 11 Tuesday, October 10, 2006 10:40 AM