PYLE Audio PLTTB3U - Manual (Page 4)

4
8. Tonearm Lever:
Use this lever to lower and raise the tonearm.
9. Tonearm Lock:
Use this to lock the tonearm in place when not in use.
10. Tonearm:
Keep locked in place when not in use.
11. Pitch Control:
Use this slider to vary the pitch of the recording by slightly speeding up or
slowing down the rotation of the platter.
12. Headshell:
This holds the stylus (“needle”) in place and provide protection by means of its
removable stylus protection cap (not shown)
13. Speed Indicators:
These lights illuminate to show which speed (33-1/3 or 45 RPM) is selected.
14. 33 RPM selector:
Use this switch to select the 33-1.3 RPM speed.
15. 45 RPM selector:
Use this switch to select the 45 RPM speed.
16. Dust Cover:
Use this to protect the turntable from exposure to dust. The cover may be
opened or removed during use, but should remain closed when the turntable is
not in use.
17. Power Cord:
Connect this cord to a grounded AC outlet of the proper voltage.
DO NOT DEFEAT THE GROUND PRONG OF THE AC PLUG
18. Signal Connectors:
Use these to connect the turntable to the mixer or amplifier in your sound
system.
19. USB port:
- With Full-Speed Transceivers
- Fully Compliant With USB 1.1 Specification
Connect to PC for editing the music with your favorite digital editing software, if
you need the information of free editing software; please check the website
http://audacity.sourceforge.net/ , and check the attached software instruction.
20. Gain: Turn to adjust the volume of USB output
21. Line/Phone switch: To select the turntable output between Line and PHONO