Polycom SpectraLink 8000 - Manual (Page 27)

Configuring the SpectraLink 8000 SVP Server
PN: 1725-36032-001_G.doc 27
RTP traffic is the audio traffic to the PBX. It requires voice quality.
PBX traffic is not audio to the PBX.
Inter-SVP2 traffic is the information-passing protocol that SVP
Servers use to communicate with each other.
The final DSCP tag of traffic for packets in each of the above Traffic
Classes is governed by the logic below when SVP is used in an SRP
environment:
• If in-call and WT (In call) value is not Default then the configured
value is used. Valid range is 0-63.
• If not in-call and WT (Standby) value is not Default then the
configured value is used. Valid range is 0-63.
• Default means “shall not change value of DSCP tag”, in other
words the received DSCP value (from the Gateway) is passed
transparently.
Reset System
If this option is selected, you will be prompted to reset the SVP Server
upon exiting this screen.
The SVP Server should be reset at the end of any maintenance
procedure that requires a reset either via
Maintenance Lock or
manually via Reset System.
Note that resetting the SVP Server will terminate any calls in
progress.
Change Password
If desired, the password to access the SVP Server may be changed.
A password must meet the following requirements:
• It must be more than four characters, but cannot exceed 16
characters.
• The first character must be a letter.
• Numbers or letters are allowed.
• No dashes, spaces, or punctuation marks, etc. are allowed.