Rear panel front panel, Rear panel, Front panel – Pioneer CDJ-2000 User Manual

Page 10

Advertising
background image

DRB1474-A

En

10

q CUE/LOOP CALL/  (page 17), DELETE (page 17), MEMORY
(page

17)

r VINYL SPEED ADJUST RELEASE/START (page

18)

s JOG ADJUST (page

18)

t JOG MODE, VINYL mode indicator and CDJ mode indicator
(page

18)

The mode switches between VINYL and CDJ each time this is pressed. The
indicator for the selected mode lights.

u TEMPO ±6/±10/±16/WIDE (page

15)

v MASTER TEMPO (page

15)

w TEMPO (page

15)

x TEMPO RESET and TEMPO RESET indicator

Regardless of the position of the TEMPO dial, tracks are played at the
original playing speed recorded on the disc, etc. The indicator lights when
TEMPO RESET

is turned on.

y Jog dial (– REV/ + FWD) and JOG RING ILLUMINATION (page

18)

z Jog dial display section (page

11)

Rear Panel

A POWER ON OFF

Press to turn the power on and off.

B AUDIO OUT L/ R (page

12)

C AC IN (page

12)

D CONTROL (page

19)

E DIGITAL OUT

F Kensington security slot

G LINK (page

12)

H USB (page

12)

Front Panel

I Disc insertion slot

J Disc force eject pin insertion hole

K Disc insertion slot indicator

About ejecting discs by force

 If the disc cannot be ejected by pressing [DISC EJECT], the disc can be

ejected forcibly by inserting the disc force eject pin all the way into the disc
force eject pin insertion hole on the main unit’s front panel.

 When forcibly ejecting a disc, be sure to do so following the procedure below.

1 Press [POWER] and wait at least 1 minute after the set’s
power has turned off.

Never forcibly eject a disc directly after turning off the set’s power. Doing so is
dangerous for the reasons described below.
The disc will still be spinning when ejected and could hit your fingers, etc.,
causing injury.
Also, the disc clamp will rotate in an unstable way, and the disc could get
scratched.

2 Use the included disc force eject pin. (Do not use anything
else.)

The included disc force eject pin is mounted on the CDJ-2000’s bottom panel.
When the pin is inserted all the way into the insertion hole, the disc is ejected 5
mm to 10 mm out of the disc insertion slot. Grasp the disc with your fingers and
pull it out.

Advertising