Precor CONSOLE P80 - Manual (Page 58)

56
Operating and Maintaining the P80 Console
To clean the screen:
 The manufacturer recommends diluting one part 91%
isopropyl alcohol solution in one part water, or using the
91% isopropyl alcohol solution in its original strength. Be
sure to follow the solvent manufacturer’s precautions and
directions when using any solvent.
CAUTION: Potentially hazardous situations associated with the
use of isopropyl alcohol may result in minor or moderate injury
and property damage. To avoid these situations, follow all
instructions and recommendations in the manufacturer’s Material
Safety Data Sheet and product label.
Important: Do not use any acidic cleaners. Doing so will weaken
the paint or powder coatings and void the Precor Limited
Warranty. Never pour water or spray liquids directly on the
console or console’s screen.
 It is important to avoid using any corrosive chemicals on the
console or screen.
 Always dampen the cloth and then clean the screen. Be sure
to spray the cleaning liquid onto the cloth, not the screen, so
that drips do not seep into the console.
 Apply the cleaner with a soft, lint-free cloth. Avoid using gritty
cloths.
Changing the Belt (Newer Model AMT Only)
The newer model AMT uses belts to provide motion. These
belts eventually wear and must be replaced.
When the belt stride count reaches 90 million, the message
BELTS MUST BE CHANGED SOON scrolls on the Welcome
screen. While this message appears, the AMT operates
normally.
Important: If this message displays on your AMT, please contact
Precor Customer Support for assistance.
When the belt stride count reaches 100 million (and the belt
has not been changed), the message BELTS CHANGE
REQUIRED scrolls continuously on the Welcome screen. The
input keys are not functional and the user cannot enter values
or begin a workout until the belts are changed. Please contact
Precor Customer Support to schedule a belt change.