Panasonic EY6506 - Manual (Page 4)

- 4 -
WARNING: WARNING:
Some dust created by power sanding,
sawing, grinding, drilling, and other
construction activities contains chemi-
cals known to the State of California
to cause cancer, birth defects or other
reproductive harm. Some examples
of these chemicals are:
Lead from lead-based paints
Crystalline silica from bricks and
cement and other masonry products
Arsenic and chromium from chemi-
cally-treated lumber.
To reduce your exposure to these
chemicals: work in a well ventilated
area, and work with approved safety
equipment, such as dust masks that
are specially designed to filter out
microscopic particles.
.FOR FOR
BATTERY CHARGER BATTERY CHARGER
& BATTERY PACK & BATTERY PACK
IMPORTANT SAFETY IMPORTANT SAFETY
INSTRUCTIONS INSTRUCTIONS
1)
SAVE THESE INSTRUC-
TIONS
- This manual contains important
safety and operating instructions for
battery charger EY0110.
2) Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack.
3)
CAUTION
- To reduce the risk
of injury, charge only Battery Pack as
shown below.
EY9065, EY9066, EY9168, EY9080,
EY9086, EY9180, EY9182, EY9001,
EY9006, EY9101, EY9106, EY9200,
EY9201, EY9136, EY9230, EY9231,
EY9251, EY9117, EY9210
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger to rain or snow.
5) To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6) Make sure cord is located so that it will
not be stepped on, tripped over, or oth-
erwise subjected to damage or stress.
7) An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock.
If extension cord must be used, make
sure that:
a. pins on plug of extension cord are
the same number, size and shape as
those of plug on charger.
b. extension cord is properly wired and
in good electrical condition.
c. wire size is large enough for ampere
rating of charger as specified below
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating. Amperes AWG Size of Cord
Equal to or
greater than But less
than Length of Cord, Feet
25 50 100 150
0 2 18 18 18 16
8) Do not operate charger with damaged
cord or plug-replace them immediately.
9) Do not operate charger if it has re-
ceived a sharp blow, been dropped, or
otherwise damaged in any way; take it
to a qualified serviceman.
10) Do not disassemble charger; take it to
a qualified serviceman when service or
repair is required. Incorrect reassembly
may result in a risk of electric shock or
fire.
11) To reduce the risk of electric shock, un-
plug charger from outlet before attempt-
ing any maintenance or cleaning.
12) The charger and battery pack are specifi-
cally designed to work together. Do not
attempt to charge any other cordless tool
or battery pack with this charger.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the bat-
tery pack housing.
15) Do not store the tool and battery pack
in locations where the temperature may
reach or exceed 50°C (122°F) (such as
a metal tool shed, or a car in the sum-
mer), which can lead to deterioration of
the storage battery.
16) Do not charge battery pack when the
temperature is BELOW 0°C (32°F)