Precision Power SEDONA S2.65C User Manual
Page 3
INSTALLING THE CROSSOVER
Step 1: Find a location for the crossover away from any fac-
tory or aftermarket electrical wires. It is recommended to
mount the passive crossover close to the amplifier.
Step 2: Remove top cover of crossover housing. Don’t lose it.
Step 3: Mark the mounting holes with a marking pen.
Step 4: Remove crossover and pre-drill mounting holes using
a 1/8” drill bit.
WARNING: Window mechanisms, electrical wires, and
other expensive car parts have a nasty habit of hiding
where you least expect. CHECK BEFORE YOU DRILL!
Step 5: Mount the crossover using the supplied #8 screws.
Step 6: There are two sets of connections on the crossover.
The input terminals (IN) should be connected to the source
(radio or amplifier). The woofer terminals (W) should be con-
nected to the midrange speaker. The tweeter terminals (TW)
should be connected to the tweeter.
Be sure to observe the
correct polarity. Changing the polarity of the tweeter may be
necessary for optimum sound quality.
Step 7: Re-install the crossover cover.
INTRODUCTION
Thank you for your purchase of this Sedona Series Compo-
nent Loudspeaker System from PrecisionPower™. Our engi-
neers have combined state of the art materials such as
formed prolypropylene cones and mylar dome tweeters with
cutting edge industrial design to achieve competition-ready
performance levels.
PRACTICE SAFE SOUND!
Continuous exposure to sound pressure levels over 100dB
may cause permanent hearing loss. High power automotive
sound systems can generate sound pressure levels in excess
of 130dB. When playing your system at high levels, please
use hearing protection and prevent long term exposure.
WHAT’S IN THE BOX
Your new Sedona Series component speaker kit includes all
the necessary mounting hardware and cables for a basic in-
stallation:
Quantity
Description
1
Installation and Operation Manual
2
Mylar
Tweeters
2
Tweeter flush mount hardware kits
2
Tweeter surface mount hardware kits
2
Component
woofers
2
Passive
crossovers
4
Speaker cables (speakers to crossover)
2
Grilles